Comparison between Fuzzy Sliding Mode and Traditional IP Controllers in a Speed Control of a Doubly Fed Induction Motor
Article Sidebar
Main Article Content
Abstract
Many industrial applications require new control techniques in order to obtain fast response and to improve the dynamic performances. One of the techniques users, fuzzy sliding mode control which is characterizes by robustness and insensitivity to the parameters variation. In this paper, we present a comparative study of a direct stator flux orientation control of doubly fed induction motor by two regulators: traditional IP controller and fuzzy sliding mode. The three regulators are applies in speed regulation of doubly fed induction motor (DFIM). The robustness between these two regulators was tested and validated under simulations with the presence of variations of the parameters of the motor, in particular the face of disturbances of load torque. The results show that the fuzzy sliding mode controller has best performance than the traditional IP controller.
Article Details
This journal provides immediate open access to its content on the principle that making research freely available to the public supports a greater global exchange of knowledge.
- Creative Commons Copyright License
The journal allows readers to download and share all published articles as long as they properly cite such articles; however, they cannot change them or use them commercially. This is classified as CC BY-NC-ND for the creative commons license.
- Retention of Copyright and Publishing Rights
The journal allows the authors of the published articles to hold copyrights and publishing rights without restrictions.
References
backstepping vector control for the doubly
fed induction motor," The Institution of Engineering
and Technology, Control Theory Appl.,
vol. 1, no. 4, pp. 861–868, 2007.
[2] S. Drid, M. Tadjine and M.S. Nait-Said, “Nonlinear
feedback control and torque optimization of
a doubly fed induction motor," Journal of Electrical
Engineering, vol. 56, no. 3-4, pp. 57–63,
2005.
[3] A. Chaari, M. Soltani and M. Gossa, “Comparative
study between the conventional regulatorsand fuzzy logic controller: application on the induction
machine," International Journal of Sciences
and Techniques of Automatic control &
computer engineering IJ-STA, vol. 1, no. 2, pp.
196–212, December 2007.
[4] H. Brian, X. Longya and T. Yifan, “Fuzzy
logic enhanced speed control of an indirect fieldoriented
induction machine drive," IEEE Trans.
Power Electronics. vol. 12, no. 5, pp 772–778,
September 1997.
[5] A. Hazzab, I. K. Bousserhane, M. Kamli and
M. Rahli, “Adaptive fuzzy PI-sliding mode controller
for induction motor speed control," International
Journal of Emerging Electric Power
Systems, vol. 4, Issue 1, Article 1084, pp 1–13,
2005.
[6] F. Barrero, A. Gonzalez, A. Torralba, E. Galvan
and L. G. Franquelo, “Speed control of induction
motors using a novel fuzzy sliding mode structure,"
IEEE Trans. Fuzzy Syst., vol. 10, no. 3,
pp. 375–383, June 2002.
[7] A. TAHOUR, H. ABID, A. G. AISSAOUI,
“Speed control of switched reluctance motor using
fuzzy sliding mode," Advances in Electrical
and Computer Engineering, vol. 8, (15), Number
1 (29), pp 21–25, 2008.
[8] P. Guillemin, “Fuzzy logic applied to motor control,"
IEEE Trans. On Ind. Appl. vol.32, pp. 51–
56, Feb.1996.
[9] C. C. Lee, “Fuzzy logic in control systems: Fuzzy
logic controller Part 1," IEEE Trans. Syst. Man,
Cyber, vol. 20, pp. 404–418, Apr. 1990.
[10] Y. Bekakra and D. Ben attous, “A sliding mode
speed and flux control of a doubly fed induction
machine," Electrical and Electronics Engineering,
IEEE Conference, 2009, pp. I-174 - I-178.
[11] M. Abid, A. Aissaoui, H. Bounoua, “Sliding
mode application in speed and flux control of
an induction machine," Journal of Electrical and
Electronics Engineering, vol. 6, no. 2, pp. 197–
204, 2006, Istanbul university.
[12] M. Abid, A. Mansouri, A. Aissaoui and B. Belabbes,
“Sliding mode application in position
control of an induction machine : Journal of electrical
engineering," vol. 59, no. 6, pp. 322–327,
2008.
[13] J. Lo and Y Kuo : “Decoupled fuzzy sliding mode
control," IEEE Trans. Fuzzy Syst., vol.6, no. 3, pp. 426–435, Aug. 1998.
[14] A. Aissaoui, M. Abid, H. Abid, A. Tahour, “Position
control of synchronous machine using sliding
mode techniques," Journal of electrical and electronics
engineering, vol. 7, no. 2, pp. 471–480,
2007, Istanbul University.
[15] E. Nechadi, M. N. Harmas, A. Ferhat-Hamida,
and K. Zehar, “Stabilisation d’un système
electro-énergétique par contrôleur flou en mode
glissant," SETIT 2005, 3rd International Conference:
Sciences of Electronic, Technologies of
Information and Telecommunications, March 27-
31, 2005, Tunisia.
[16] B. ALLAOUA, B. GASBAOUI and B.
MEBARKI, “Setting up PID DC motor speed
control alteration parameters using particle
swarm optimization strategy," Leonardo Electronic
Journal of Practices and Technologies,
Issue 14, pp. 19–32, January-June 2009.