Field Programmable Gate Array-Based Execution on a Distributed Energy Resource Supported Electrical Distribution System for Enhanced Power Quality with Optimal Active Power Flow Control

Main Article Content

Jogeswara Sabat
Mrutyunjaya Mangaraj

Abstract

This paper explains the experimental study of a distributed energy resource (DER) integrated three-phase, three-wire electrical distribution system (EDS) under power quality (PQ) and optimal active power flow control (OAPFC). In this research, a back-to-back connected two-level VSI (BTB-TVSI) based distribution static compensator (DSTATCOM) for unbalanced non-linear load is designed. The aim is to provide better OAPFC in EDS with shunt compensation to maintain a round-the-clock quality power supply for end users. The improved neural network-based adaptive least mean square (ALMS) control algorithms are employed for DSTATCOM. The ALMS control strategy is realized using the SPARTAN-6 field programmable gate array (FPGA) evaluation kit. This research involves the comparative study of a two-level voltage source inverter (VSI) and a BTB-TVSI in terms of their OAPFC capability and robustness in mitigating power quality (PQ) against source current disturbances, low power factor (PF), poor voltage regulation, unbalanced voltage at the point of common coupling (PCC), high switching stress, and issues in the EDS operation. The experimental results demonstrate that the BTB-TVSI using an ALMS controller is able to achieve better dynamic performance and lower total harmonic distortion (THD) under selected/permissible limits in comparison to a conventional VSI.

Article Details

How to Cite
Sabat, J., & Mangaraj, M. (2023). Field Programmable Gate Array-Based Execution on a Distributed Energy Resource Supported Electrical Distribution System for Enhanced Power Quality with Optimal Active Power Flow Control. ECTI Transactions on Electrical Engineering, Electronics, and Communications, 21(1), 248571. https://doi.org/10.37936/ecti-eec.2023211.248571
Section
Publish Article

References

B. Singh, F. Chishti, and S. Murshid, “Disturbance rejection through adaptive frequency estimation observer for wind-solar integrated AC microgrid,” IEEE Transactions on Industrial Informatics, vol. 15, no. 11, pp. 6035–6047, Nov. 2019.

J. Sabat and M. Mangaraj, “GLMS control strategy based DSTATCOM for PQ enhancement: modeling and comparative analysis,” Energy Systems, 2021.

R. Arulmurugan, “Photovoltaic powered transformerless hybrid converter with active filter for harmonic and reactive power compensation,” ECTI Transactions on Electrical Engineering, Electronics, and Communications, vol. 16, no. 2, pp. 44–51, Feb. 2018.

S. Samal, P. K. Barik, and P. K. Hota, “Harmonics mitigation of a solar PV-fuel cell based microgrid system using a shunt active power filter,” ECTI Transactions on Electrical Engineering, Electronics, and Communications, vol. 19, no. 2, pp. 127–135, Jun. 2021.

M. Mangaraj and A. K. Panda, “Performance analysis of DSTATCOM employing various control algorithms,” IET Generation, Transmission & Distribution, vol. 11, no. 10, pp. 2643–2653, Jul. 2017.

B. Singh, P. Jayaprakash, D. P. Kothari, A. Chandra, and K. A. Haddad, “Comprehensive study of DSTATCOM configurations,” IEEE Transactions on Industrial Informatics, vol. 10, no. 2, pp. 854–870, May 2014.

M. Davari, M. P. Aghababa, F. Blaabjerg, and M. Saif, “An innovative, adaptive faulty signal rectifier along with a switching controller for reliable primary control of GC-VSIs in CPS-based modernized microgrids,” IEEE Transactions on Power Electronics, vol. 36, no. 7, pp. 8370–8387, Jul. 2021.

A. Aghazadeh, M. Jafari, N. Khodabakhshi-Javinani, H. Nafisi, and H. J. Namvar, “Introduction and advantage of space opposite vectors modulation utilized in dual two-level inverters with isolated DC sources,” IEEE Transactions on Industrial Electronics, vol. 66, no. 10, pp. 7581–7592, Oct. 2019.

M. Mangaraj and J. Sabat, “MVSI and AVSI-supported DSTATCOM for PQ analysis,” IETE Journal of Research, 2021.

M. Car, V. Lesic, and M. Vasak, “Cascaded control of back-to-back converter DC link voltage robust to grid parameters variation,” IEEE Transactions on Industrial Electronics, vol. 68, no. 3, pp. 1994–2004, Mar. 2021.

A. D. Kiadehi, K. E. K. Drissi, and C. Pasquier, “Angular modulation of dual-inverter fed open-end motor for electrical vehicle applications,” IEEE Transactions on Power Electronics, vol. 31, no. 4, pp. 2980–2990, Apr. 2016.

R. P. Kandula, A. Iyer, R. Moghe, J. E. Hernandez, and D. Divan, “Power router for meshed systems based on a fractionally rated back-to-back converter,” IEEE Transactions on Power Electronics, vol. 29, no. 10, pp. 5172–5180, Oct. 2014.

I. Jlassi, J. O. Estima, S. K. E. Khil, N. M. Bellaaj, and A. J. M. Cardoso, “Multiple open-circuit faults diagnosis in back-to-back converters of PMSG drives for wind turbine systems,” IEEE Transactions on Power Electronics, vol. 30, no. 5, pp. 2689–2702, May 2015.

L. Tarisciotti, P. Zanchetta, A. Watson, S. Bifaretti, and J. C. Clare, “Modulated model predictive control for a seven-level cascaded h-bridge back-to-back converter,” IEEE Transactions on Industrial Electronics, vol. 61, no. 10, pp. 5375–5383, Oct. 2014.

C.-Y. Tang, Y.-F. Chen, Y.-M. Chen, and Y.-R. Chang, “DC-link voltage control strategy for three-phase back-to-back active power conditioners,” IEEE Transactions on Industrial Electronics, vol. 62, no. 10, pp. 6306–6316, Oct. 2015.

D. V. M., B. Singh, and G. Bhuvaneswari, “A high-performance microgrid with a mechanical sensorless SynRG operated wind energy generating system,” IEEE Transactions on Industrial Informatics, vol. 16, no. 12, pp. 7349–7359, Dec. 2020.

J. Fei and Y. Chen, “Dynamic terminal sliding-mode control for single-phase active power filter using new feedback recurrent neural network,” IEEE Transactions on Power Electronics, vol. 35, no. 9, pp. 9904–9922, Sep. 2020.

M. Mangaraj and A. K. Panda, “Modelling and simulation of KHLMS algorithm-based DSTATCOM,” IET Power Electronics, vol. 12, no. 9, pp. 2304–2311, Aug. 2019.

A. P. Kumar and M. Mangaraj, “DSTATCOM employing hybrid neural network control technique for power quality improvement,” IET Power Electronics, vol. 10, no. 4, pp. 480–489, Mar. 2017.

R. K. Agarwal, I. Hussain, and B. Singh, “Application of LMS-based NN structure for power quality enhancement in a distribution network under abnormal conditions,” IEEE Transactions on Neural Networks and Learning Systems, vol. 29, no. 5, pp. 1598–1607, May 2018.

T. Penthia, A. K. Panda, and M. Mangaraj, “Experimental validation of ADALINE least mean square algorithm in a three-phase four-wire DSTATCOM to enhance power quality,” Electric Power Components and Systems, vol. 48, no. 8, pp. 769–780, 2020.

T. A. Naidu, S. R. Arya, R. Maurya, and S. Padmanaban, “Performance of DVR using optimized PI controller based gradient adaptive variable step LMS control algorithm,” IEEE Journal of Emerging and Selected Topics in Industrial Electronics, vol. 2, no. 2, pp. 155–163, Apr. 2021.

B. Singh, S. R. Arya, A. Chandra, and K. Al-Haddad, “Implementation of adaptive filter in distribution static compensator,” IEEE Transactions on Industry Applications, vol. 50, no. 5, pp. 3026–3036, Sep. 2014.

M. Badoni, A. Singh, and B. Singh, “Comparative performance of Wiener filter and adaptive least mean square-based control for power quality improvement,” IEEE Transactions on Industrial Electronics, vol. 63, no. 5, pp. 3028–3037, May 2016.

V. N. Jayasankar and U. Vinatha, “Backstepping controller with dual self-tuning filter for single-phase shunt active power filters under distorted grid voltage condition,” IEEE Transactions on Industry Applications, vol. 56, no. 6, pp. 7176–7184, Nov. 2020.

IEEE Recommended Practice for Monitoring Electric Power Quality, IEEE Std 1159-2019 (Revision of IEEE Std 1159-2009), Aug. 2019.

IEEE Recommended Practice for the Planning and Design of the Microgrid, IEEE Std 2030.9-2019, Jul. 2019.

Y.-K. Wu, S.-M. Chang, and P. Mandal, “Grid-connected wind power plants: A survey on the integration requirements in modern grid codes,” IEEE Transactions on Industry Applications, vol. 55, no. 6, pp. 5584–5593, Nov. 2019.