Active – RC Filter Synthesis by Section Substitution Method
Main Article Content
Abstract
In this paper, section substitution method for active-RC filter synthesis is presented. The presented method is modular than the operational simulation method and can be used to design various types of ladder-based active-RC filters suitable for practical integrated circuit implementation. Several low-pass and band-pass filter design examples are given.
Article Details
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Copyright @2021 Engineering Transactions
Faculty of Engineering and Technology
Mahanakorn University of Technology
References
R. Schaumann and M. E. Van Valkenburg, Design of Analog Filters, Oxford University Press, 2001.
K. Martin and A. S. Sedra, “Design of Signal-Flow Graph (SFG) Active Filters,” IEEE Transactions on Circuits and Systems, Vol. 25, No. 4, pp. 185 – 194, April 1978.
M. Banu and Y. Tsividis, “An Elliptic Continuous-Time CMOS Filter with On-Chip Automatic Tuning,” IEEE Journal of Solid-State Circuits, Vol. SC-20, pp. 1114-1121, December 1985.
J. Mahattanakul, P. Khumsat, and W. Surakampontorn, “Ladder-simulation elliptic bandpass active-RC filter structure employing identical resistors,” IET Circuits Devices Syst., vol. 3, pp. 187-196, April 2009.
S. Signell and K. Mossberg, “Design of high-frequency active-RC filters using passive compensation methods,” in Proc. International Symposium on Circuits and Systems (ISCAS), Vol. 3, pp. 2669 – 2672, June 1988.
N. Nen-ngam and J. Mahattanakul, “Analysis of phase noise in LC oscillator,” Engineering Transaction,” Vol. 12, No. 1, pp. 29 – 39, 2009.