Influence of Drying Air Velocity Characteristics on Paddy Drying

Main Article Content

Nuttapong Wongbubpa
Krawee Treeamnuk
Tawarat Treeamnuk

Abstract

The objective of this research was to study the influence of drying air velocity characteristics on paddy drying. The pneumatic dryer prototype was used in this study. Test drying 15 kg of Hom Pathum paddy at 22 – 25% initial wet basis moisture content was tested drying under the drying air temperature 80OC until its moisture is 14% wet basis with the two drying air velocity characteristics. The first characteristic of drying air velocity is constant at 12.80 m/s and another is reduced velocity every 15 minutes throughout the test process from 12.80 - 8.44 m/s. Drying in a vertical tube with a diameter of 3.81 cm and height 1 m for study the drying behavior, drying rate (DR), specific energy consumption (SEC), and thermal efficiency of drying. The results showed that drying with constant air velocity gives a shorter time, higher drying rate, lower primary SEC consumption, and higher thermal efficiency than drying with reducing air velocity.

Article Details

How to Cite
[1]
N. Wongbubpa, K. Treeamnuk, and T. Treeamnuk, “Influence of Drying Air Velocity Characteristics on Paddy Drying”, RMUTP RESEARCH JOURNAL, vol. 16, no. 1, pp. 165–176, Jun. 2022.
Section
บทความวิจัย (Research Articles)

References

Department of Agriculture, Quality and Inspection of Thai Hom Mali Rice. Bangkok Thailand, Jirawat express co., ltd. 2004.

S. Prachayawarakorn, S. Ruengnarong and S. Soponronnarit, “Characteristic of heat transfer in two-dimensional spouted bed,” International Journal of Food Engineering Research, vol. 76, pp 327-333, 2006.

Z. Sun, W. Yang, T. Siebenmorgen, A. Stelwagen and A. Cnossen, “Thermomechanical transitions of rice kernels,” Cereal Chemistry, vol. 79, no. 3, pp. 349-353, 2002.

T. Chitsomboon, S. Khaengkarn and K. Pechnumkheaw, “Free-fall-paddy rice dryer: A fast and energy efficient dryer,” in Proceeding of the 2nd Conference on Energy Network of Thailand, 2006.

K. Pechnumkheaw, S. Meesukchaosumran and T. Chitsomboon, “Effect of Air Velocity on Drying Rate of Paddy Using Continuous Free-fall Technique,” in Proceeding of the 22nd Conference on Mechanical Engineering Network of Thailand, 2008.

S. Meesukchaosumran and T. Chitsomboon, “Free-Fall Dryer: Appropriate Drying Condition for Good Rice Quality,” in Proceeding of the 23rd Conference of the Mechanical Engineering Network of Thailand, 2009.

T. Wichinthanasan, W. Ritthong and K. Sathapornprasath, “Paddy dehydration using Impinging stream dryer combined with Pneumatic dryer,” in Proceeding of the 25th Conference of the Mechanical Engineering Network of Thailand, 2011.

A.G. Cnossen, T.J. Siebenmorgen and W. Yang, “The glass transition temperature concept in drying and tempering: effect of drying rate,” American Society of Agricutural Engineering (ASAE), vol. 45, no. 3, pp 759-766, 2002.

P. Ondokmai, N. Homdoung, N. Dussadee, P. Yongphet, S. Bouchareon and R. Ramaraj, “Performance of Paddy Greenhouse Solar Dryer Operate with Hybrid Gasification Technology,” in Proceeding of 23rd Tri-U International Joint Seminar and Symposium Bogor Agricultural University, Indonesia, 2016.

S. Aktar, R. Kibria, M.M. Alam, M. Kabir and C.K. Saha, “Performance Study of STR Dryer for Paddy,” J. Agril. Mach. Bioresour. Eng, vol. 7 no. 1, pp. 9–16, 2016.

C.K. Saha, Md.A. Alam, Md.M. Alam and P.K. Kalita, “Field Performance of BAU-STR Paddy Dryer in Bangladesh,” ASABE 2017 Annual International Harvey J., 2017.

N. Saelim, T. Treeamnuk and K. Treeamnuk, “Development of a Continuous Flow Paddy Dryer with Infrared Radial Radiation Technique,” RMUTP Research Journal, vol. 12, no. 2, Jul.-Dec. 2018.

N. Wongbubpa, K. Treeamnuk and T. Treeamnuk, “Kinematics motion of paddy in hot air pulse flow,” in Proceeding of the 13th TSAE International Conferences 187, Suranaree University of Technology, Thailand, 2020.

N. Wongbubpa, K. Treeamnuk and T. Treeamnuk, “Computer Simulation Study of Paddy Motion in Hot Air Drying Chamber,” in Proceeding of the 22nd TSAE National Conferences, Khon Kaen University, Thailand, 2021.

S. Limpiti and V. Changrue, “Effects of rewetting on milling quality of wet season Japanese rice,” Journal of Agricultural, vol. 12, no. 2, pp. 134-139, 1996.

AOAC (Association of Official Analytical Chemists), “Official Methods of Analysis,” 17th ed., Association of Official Analytical Chemists, Gaithersburg, Maryland, 2000.

T. Treeamnuk, “Drying and Storage of Agricultural Products,” School of Agricultural Engineering, Institute of Engineering, Suranaree University of Technology, pp. 130-138, 2011.

N. Wongbubpa and T. Chitsomboon, “Effectiveness of The Elbowed Spouted Bed Paddy Dryer,” in Proceeding of the 29th Conference of The Mechanical Engineering Network of Thailand, Nakhon Ratchasima, 2015.

Y.A. Cengel, Heat and Mass Transfer, 3th ed. Published by McGraw-Hill Companies, Inc., 1221 Avenue of the Americas, New York, NY 10020, 2006.