Induction Cooking for Two Outputs Independent Power Adjustment by Asymmetrical Control

Authors

  • Kantaphon Lonphan Department of Electrical Power Engineering Technology Faculty of Industrial Technology, Pibulsongkram Rajabhat University
  • Surachet Mitsanon Department of Electrical Power Engineering Technology Faculty of Industrial Technology, Pibulsongkram Rajabhat University
  • Aumpol Pichaicherdand Department of Mechanical Technology, Faculty of Technical Education,Rajamangala University of Technology Krungthep
  • panithan chakkuchan Department of Aircraft Maintenance Engineering, Faculty of Engineering, Rajamangala University of Technology Krungthep

Abstract

This paper proposes a dual-output induction heater that can adjust the output power separately using the IC dsPIC30F2020. Inverter drive signal control. The 230V input side voltage system has an input power size of 3 kW. It works in a resonance frequency range of 35-40 kHz. The output side power can also be adjusted. The standard phase-balanced voltage control is a 10% - 50% duct cycle signal to divide the flow through the switch at the inverter and divide in two sets the operation of an inverter so that it can operate with a load on the outlet. Two sets separate the heat operation separately by having a high-frequency signal switch. And the inductive cylinder conducts heat. From testing to boiling water at the cylinders, it takes approximately 12% of the time, and it takes about 3 minutes.

References

รัชพงศ์ ประเสริฐสิน, และวีรวัฒน์ ประสิทธิไกร. 2557. “เตาย่างกระทะร้อนแบบ เหนี่ยวนำ.” ปริญญานิพนธ์วิศวกรรมศาสตรบัณฑิต สาขาวิชาวิศวกรรมไฟฟ้า ภาควิชา วิศวกรรมไฟฟ้าและโทรคมนาคม คณะวิศวกรรมศาสตร์ มหาวิทยาลัยเทคโนโลยีราชมงคล กรุงเทพ.

เกียรติศักดิ์ ผาสุกมูล, และวิริยะ พิเชฐจำเริญ. 2550. “รีโซแนนท์อินเวอร์เตอร์ที่มีการ ควบคุมแรงดันแบบไม่สมมาตร.” ปริญญานิพนธ์วิศวกรรมศาสตรบัณฑิต ภาควิชา วิศวกรรมไฟฟ้า คณะวิศวกรรมศาสตร์ สถาบันเทคโนโลยีพระจอมเกล้าเจ้าคุณทหาร ลาดกระบัง.

José M. Burdío, Fernando Monterde, José R. García, Luis A.Barragán, and Abelardo Martínez. 2005. “A Two-Output Series-Resonant Inverter for Induction-Heating Cooking Appliances.” IEEE Transaction on Industrial Electronics. Vol.20, No.4 (July) : 815 - 822.

S. Chudjuarjeen, S. Jayasuriya, S. Yachiangkam, J.C. Jimenez,C.O.Nwankpa , K.Miu and A. Sangswang, .Analysis of Measurement Delay Errors in a DC-DC Buck-Boost Converter using Stochastic Differential Equations.in Proceeding of37th Annual Conference of the IEEE Industrial Electronics Society (IECON 2011), Melbourne, Australia; 2011.

Phankong, N., Jittakort, J., Chakkuchan P., Kirdpipat, P., Methavithit, W., & Anusurain, E. Electric Grill Using Energy from Battery. In: 2021 18th International Conference on Electrical Engineering/ Electronics, Computer, Telecommunications and Information Technology (ECTI-CON). IEEE, 2021. p. 972-975.

Phankong, N., Chakkuchan, P., Jittakort, J., Paivimut, N., Kamonkhantithon, C., & Chudjuarjeen, S. Photovoltaic Cell Energy Transfer System Using Series Connected Bidirectional Resonant Converters. In: 2021 18th International Conference on Electrical Engineering /Electronics, Computer, Telecom munications and Information Techno logy (ECTI-CON). IEEE, 2021. p. 976-979.

Chakkuchan, P., Chudjuarjeen, S., Phankong, N., Dangeam, S., Nawong, M., & Nintanavongsa, P. Full-Bridge Current Source Inverter Using Pulse Density Control for Induction Preheating of Welding Application.2022 25th Inter national Conference on Electrical Machines and Systems (ICEMS). IEEE, 2022. p. 1-4.

Nilboworn S, Mahamad K, Sangchay W, et al. Edge effect and its influence on the adjacent cavities in a composite insulator. UTK RRSEARCH JOURNAL.,2020; 14(1): 23-29.

C.Wisassakichai,P.Phaochoo, E.Anusu rain, C.Kamonkhantithorn, W.Metha vithit, W.Sirichanon “Database Builging with Microsoft Excel for Voltage Drop Calcuation according to Thai Electrical Code 2013 with C++ Builder” UTK RRSEARCH JOURNAL.2018; 12(2): pp. 119-135.

B.Sriboonreung “Two output power control of induction cooker with full bridge inverter controlled by asym metrical voltage control” UTK RRSEARCH JOURNAL. 2019; 13(2): pp. 1-11.

J.Ekburanawat “Full bridge switching power supply for a thermoelectric dehumidifier” UTK RRSEARCH JOURNAL. 2019; 13(2): pp. 53-63.

N. Phankong, J.Jittakort, P.Chakkuchan, S.Kitcharoenwat, V. Hathairatsiri, C. Wisa ssakwichai, S. Chudjuarjeen, “Induction Heating Application using Frequency Control Techniques for Hot Tensile Testing”, 2021 18th International Conference on Electrical Engineering /Electronics, Computer, Telecom munications and Information Technology (ECTI-CON), Pages 968-971.

N. Phankong, J. Jittakort, P. Chakkuchan, P. Kirdpipat, W. Methavithit, E. Anusurain, “Electric Grill Using Energy From Battery”, 2021 18th International Conference on Electrical Engineering /Electronics, Computer, Telecom munications and Information Technology (ECTI-CON), pp. 972-975.

Aniket G. Kothalker, Prof. Mangesh A. Ahire “Hot Tensile Test – A Literature Review,” IJMTER International Journal of Modern Trends in Engineering and Research, Date 2-4 July 2015, pp. 1772-1776.

M.Ganapathy, N.Li, J. Lin, M.Abspoel, D. Bhattacharjee, “ A Novel Grip Design for High-Accuracy Thermo-Mechanical Tensile Tesing of Boron Steel under Hot Stamping Conditions, Experimental Mechanics, An International Journal Integrating Experimental Methods with the Mechanical Behavior of Materials and Structures, Date 21 Aug 2017, pp. 243-258

Downloads

Published

2023-12-28

How to Cite

[1]
K. Lonphan, S. . Mitsanon, A. Pichaicherdand, and panithan chakkuchan, “Induction Cooking for Two Outputs Independent Power Adjustment by Asymmetrical Control”, UTK RESEARCH JOURNAL, vol. 17, no. 2, pp. 1–12, Dec. 2023.

Issue

Section

Research Articles