Study and Design Vertical Axis Wind Turbine for Low Wind Speed Area

Authors

  • วีระศักดิ์ ไชยชาญ Faculty of Engineering, Rajamangala University of Technology Srivijaya, Trang Campus
  • ศักราช ทองนอก Faculty of Engineering, Rajamangala University of Technology Srivijaya, Trang Campus
  • เพียรดี อ่อนยิ่ง Faculty of Engineering, Rajamangala University of Technology Srivijaya, Trang Campus
  • ภูเทพ วรรณบวร Faculty of Engineering, Rajamangala University of Technology Srivijaya, Trang Campus

Keywords:

Wind Turbine, Blade, DC Generator, Renewable Energy

Abstract

This research presents a study and design of vertical axis wind turbine. The purpose of this research was to design the vertical axis wind turbine blade that is suitable for operating at low wind speed area. The designs of wind turbine blades are measured 0.2 meters long, 0.8 meters wide to comprise as a multi-blade vertical axis (two, three, four, five and six blades). DC generator (28W) is installed to connect to the wind turbine through a gear box at velocity ratio of 1:2.67. Electric power from DC generator is charged in the storage battery 12V 5Ah through a charge controller. From the study, it was found that at wind speed of 3.9 m/s, six
blades vertical axis wind turbine can be generated the maximum voltage, current and power for the load (10W) of 15.41V, 0.33A and 5.09W, respectively. The electric power generation can charge the 12.98V battery to 100% state within 4 hours and 40 minutes.

 

References

[1] กรมพัฒนาพลังงานทดแทนและอนุรักษ์พลังงาน. 2553. โครงการพัฒนาปรับปรุงแผนที่ศักยภาพพลังงานลมสำหรับประเทศไทย.
กรุงเทพมหานคร.

[2] นนทวุฒิ ปรีชาวุฒิ. 2552. การออกแบบใบกังหันลมแกนนอนที่เหมาะสมสำหรับความเร็วลมต่ำ. มหาวิทยาลัยเทคโนโลยีพระจอมเกล้าพระนครเหนือ.

[3] วีระ ธันยาภิรักษ์ และ เอกวิทย์ หายักวงษ์.2552. รายงานการวิจัยเรื่อง การศึกษาศักยภาพการผลิตไฟฟ้าด้วยพลังงานลมในเขตอำเภอ พังโคน จังหวัดสกลนคร. มหาวิทยาลัยเทคโนโลยีราชมงคลอีสาน วิทยาเขตสกลนคร.

[4] วิรชัย โรยนรินท์, บุญฤทธิ์ ประสาทแก้ว และ ภาณุ ประทุมนพรัตน์. 2552. รายงานการวิจัย เรื่อง กังหันลมผลิตกระแสไฟฟ้าบนถนน. มหาวิทยาลัยเทคโนโลยีราชมงคลธัญบุรี.

[5] John wiley sons., Ltd. International journal of energy research, Vol: 25. pp 501-506.

[6] Kohara Gear Industry Co.,Ltd. Gear Technical Reference, pp. 599.

[7] Paluta M., Reitz D., Snelling R. and Gadient J. 2013. Design and Fabrication of a Vertical Axis Wind Turbine.
University of Notre Dame.

[8] Raj, A., Gurav, R. B., Saha, A., Chavan, D.S., Karandikar, P. B. and Sankpal, J. B. 2016. Study of output parameters of horizontal axis wind turbines using experimental test setup. In International Conference on Computation of Power
Energy Information and Communication. IEEE Conference Publications. pp. 363 -368. Sciences. Net. 2011. A low-cost,
open source wind turbine. 1nd edition

Downloads

Published

2018-09-21

How to Cite

[1]
ไชยชาญ ว., ทองนอก ศ., อ่อนยิ่ง เ., and วรรณบวร ภ., “Study and Design Vertical Axis Wind Turbine for Low Wind Speed Area”, UTK RESEARCH JOURNAL, vol. 11, no. 2, pp. 17–25, Sep. 2018.

Issue

Section

Research Articles